1 Reply Latest reply on Jan 22, 2015 9:53 PM by vavc

    Slave FIFO and PORTS Mode Together

    recep.kaya

       Hello,

         

      I want to use FX2LP in 8 Bit slave FIFO mode but using vendor command I want to change I/O values then return to slave FIFO mode.

         

      During vendor command operation PD4 value is set to '0' by firmware but when return to slave FIFO mode it could not retain its value and becomes '1'. Is there a way to retain  value as '0' while operating in slave  FIFO mode.

         

      Thanks..