- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I accidentally flashed RAM instead of flashing SPI Flash from Cypress Control Center. I have a Denebola kit from e-con and now the camera doesn't stream image.
Can you please suggest a workaround?
Thanks!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I know RAM isn't supposed to effect the working state as the data should lose after a power cycle, but is there something else that could have caused the behavior?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The RAM will loose its contents right after a power cycle. You can just set the PMODE pins to F11 (OFF-ON-ON) and then power cycle. It should get you back to the bootloader.
Now to your original question: did you mean that the same firmware streams video when it was loaded from SPI Flash but not when it was loaded directly from RAM?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Ah, figured out the issue. It wasn't the RAM, some issue with the drivers.
I can boot from SPI. But the software doesnt even find the camera if I am on RAM, which I believe is the same mode as Boot mode.