6 Replies Latest reply on Feb 18, 2015 12:12 PM by richa.agrawal

    JTAG Debugger

    richa.agrawal

      Hi,

         

      I amusing Segger J-Link to debug the firmware. I followed the steps outlined in section 12.3 of Programmer's Manual but I end up with the following error: 

         

       

         

      660^done
      (gdb)
      661-data-disassemble -s 0x0 -e 0x3c -- 1
      661^error,msg="Cannot access memory at address 0x40010758"
      (gdb)
      662-data-disassemble -s 0x1 -e 0x45 -- 1
      662^error,msg="Cannot access memory at address 0x40010758"
      (gdb)
      663-data-disassemble -s 0x2 -e 0x46 -- 1
      663^error,msg="Cannot access memory at address 0x40010758"
      (gdb)
      ...............

         

       

         

      How do I resolve this one?

         

       

         

      Thanks!