Apr 01, 2015
11:57 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 01, 2015
11:57 AM
Hello everybody,
I have a little problem with a PSoC1 device I am using, CY8C23433-PVXI. The documentation states that it has 256 bytes of SRAM. I have a small application that uses 19 bytes and the compiler reports that 8% of RAM is used. However, when I compile the same project on a CY8C21345-SXI (documentation says 512 bytes of SRAM), I get the same report: RAM 8% full. 19 bytes used (does not include stack usage).
Shouldn't be the reports different?
Thank you!
Labels
2 Replies
Apr 01, 2015
12:42 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 01, 2015
12:42 PM
Confirmed, I would suggest you file a MyCase (top of this page, Support & Community -> Technical Support -> Create a MyCase)
You will get response by a Cypress engineer.
Bob
Apr 01, 2015
01:31 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 01, 2015
01:31 PM
You could also file a support case at -
support@imagecraft.com support@imagecraft.com
Regards, Dana.