Note, there are two USB connections on your Kit-001. The first one is for programming and debugging the board, while the second is connected to the PSoC directly supporting the USBUART.
Are you using a Kit-001 or a Kit-050?
Cypress has an SDK kit for USB development, which has the current
drivers. These drivers are for the windows side that allow win to talk
to a USB device with a specific set of properties and ID.
Some general info on USB -
http://www.cypress.com/?rID=70131 AN82072 - PSoC® 3 and PSoC 5LP USB General Data Transfer with Standard HID Drivers
http://www.cypress.com/?rID=39553 AN56377 - PSoC® 3 and PSoC 5LP - Introduction to Implementing USB Data Transfers
http://www.cypress.com/?rID=39404 AN57473 - USB HID Basics with PSoC® 3 and PSoC 5LP
http://www.cypress.com/?rID=39327 AN57294 - USB 101: An Introduction to Universal Serial Bus 2.0
http://www.cypress.com/?rID=40103 AN58726 - PSoC® 3 / PSoC 5LP USB HID Intermediate (with Keyboard and Composite Device)
Thanks for the reply and information. I am using kit -050
i want to use usbuart in psoc 5LP for that i m not getting how to connect the rx tx of usb to the board, is it any particulr pin that we should connect .....?
When in .cydwr view to assign the pins there will be only one combination offered, probably P15_6 and p15_7.
There are no Rx and Tx pins in a USBUART component, it is a USB interface and on the PC side the UART com-port is emulated.
There are two USB connectors on your board, one is for programming the chip and debugging, the other is the USB interface of your PSoC5. You will need to connect both of them.