5 Replies Latest reply on May 11, 2015 5:18 PM by userc_41480

    Programming PSOC4




      I am not sure if this is the most appropriate forum but as my question is related to the PSOC 4200, I thought I would start here.


      We have a product that uses the CY8C4245PVI-482.


      We are about to contract out assembly of 1000 of our product


      What I want to do is supply the contract company a pre-programmed controller. Each must have a serial number.


      1) Is there a service that can perform production programming (or do you know if we can purchase from Cypress pre-programmed with our firmware)


      2) Does the device have a unique serial number built-in we could use or would we need to have the firmware somehow serialized ? We do not care what the numbers are as long as we can derive unquiqe value between 1 and 65535.


      In other products we use the Dallas serial number IC but we have no room or pins available on the board for this.