May 13, 2015
07:07 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 13, 2015
07:07 AM
PSoC Programmer 3.22.3 is installed on Windows7, 64-bit. When trying to use MiniProg3, the failure message "SetLedState(..) failed in MiniProg3" is displayed.
Check if the MiniProg3 is connected to an USB3.0 Port. If so, move it to an USB 2.0 port, and it will start to work normally. This is because when MiniProg3 was designed, it was not qualified for USB3.0 compatibility.
Labels
- Labels:
-
PSoC 1
1 Reply
May 19, 2015
12:37 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 19, 2015
12:37 AM
Thank you for sharing this information.