We don't get your point .I checked it again and I don't any difference.
In creator there is no eval board option. There is only CYBLE-022001-00.
Please give exact pionters of the error that you found out.
See the attched file
The picture is from Cypress specification
Look the left -side in this picture and you will see that P1_3
Actually there is no P1_3 in EZ-Module
By the way, EZ-Module has P4_0 (Open PSoC Creator and you will see it)
But there is no P4_0 on the green EVAL board.
1) There is no pin 1_3 on the CYBLE-022001-EVAL board/chip. It sounds like you are suggesting redoing the layout to have pin 4_0 replace the pin 1_3 on the pioneer board only?
2) The EVAL board is mainly for evaluation purposes I would suspect, and thus you only need to verify that the chip will do what you want? Why do you need access to the pin 4_0 specifically? Any of the other pins already broken out should be good enough to demonstrate functionality for the chip.