Anonymous
Not applicable
May 26, 2015
01:25 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 26, 2015
01:25 PM
Hi, I am using the PRoC eval module (black PCB) and I'm trying to figure out how to change the name of the device through a mobile app. Is there a selection in Creator's schematic editor to allow for this? Or, do I need to write custom code?
Erik
Labels
- Labels:
-
BLE
3 Replies
Anonymous
Not applicable
May 26, 2015
02:03 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 26, 2015
02:03 PM
Hi please find the attached project.
Program the psoc4 ble with this project.
Connect to this device from your phone.
Use GattDb and write the name to the characteristic .You have to write the ASCI characterisitcs for each letter
After writing, disconnect and scan again.you can see the updated name of the device.
Regards,
VIkas
Attachments are accessible only for community members.
Anonymous
Not applicable
May 26, 2015
02:04 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 26, 2015
02:04 PM
Jun 11, 2016
05:23 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 11, 2016
05:23 AM
VAVC, That link you give doesn't seem to work for me. Do you have another? Thanks