- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello guys, I have a little doubt:
I planning to buy the CY8CKIT-042-BLE Pioneer Kit and I would know if I can use the BLE Pioneer Baseboard to program the Psoc 4 BLE Module and use this module (just the psoc 4 ble module) separated of the Baseboard in my application. I want to know if I have to use the Psoc 4 BLE module just with the Baseboard because in my application I have physical limitation and I want to use only the small components.
Sorry if it is a silly question.
Att,
- Labels:
-
BLE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can get the PSoC4 BLE module separately and you just have to provide power to let the programmed module work. Have a look at the specs.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks for replying, bob! But I need the baseboard to program the module, right?
att,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can use miniprog3 and connect the SWD lines of module to program PSOC4 BLE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You need a programmer to program the module. Full stop.
There are some different choices:
The KIT-baseboard. Plugs and sockets are not layed out for too often usage, so good for prototyping.
A separate KitProg: Snap-off part of the CY8CKIT-059. Can be connected with a cable.
MiniProg3: The professional solution. Target can be powered by MiniProg3 with 3.3V or 5V
Bob