Anonymous
Not applicable
Jun 04, 2015
03:19 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 04, 2015
03:19 AM
I would like to know how to integrate an oled with the psoc 4 ble . It uses an I2C prototcol so will the pins 3.4 and 3.5 ne sufficient ?
If not please tellme how to do this?
Labels
- Labels:
-
BLE
2 Replies
Anonymous
Not applicable
Jun 04, 2015
01:03 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 04, 2015
01:03 PM
Hi ,
PSOC4 BLE has two scbs which can be programmed as i2C. So you use the I2C lines.
You can choose the appropriate pins for I2C lines.Refer table 4 in the datasheet http://www.cypress.com/?docID=50617
Regards,
Vikas
Jun 04, 2015
04:37 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 04, 2015
04:37 PM
Here is a project doing that -
www.hackster.io/rayburne/psoc-4-using-the-color-glcd-ili9341
Regards, Dana.