Another thought is to place fixed tone on line thru your board
interface so that you can look at line with scope and/or spectrum
analyzer to see what signal path looks like.
Be very careful about scope probing and grounds to make sure
you do not violate scope/analyzer input constraints. Maybe consider
using scope differentially, eg. one channel/probe becomes reference,
another channel/probe becomes signal probe. At minimum consult scope/
analyzer manual for peak AC and DC input constraints.
Use one hand/arm measurement techniques when you proble HV circuits.
Hi, I`m a newbie for bolth Arduino programming and interfacing with the CY8CPLC10 through I2C but, I have two CY3273 (low voltage evaluation boards) and I would like to use them in an applciation.
First of all I tested the functionality of the boards with the I2C > USB board they provide, I`ve connected them to my PC, and I can send/receive hex messages.
Now I would like to connect one of the boards to the PC, and send data to the other board/node and read the data with the Arduino UNO I2C interface. I`ve read the Application nodes for Designing an external host, I understood it, but beacause of my lack of knowledge in this area I would need some help. Maybe an example of simple reading the data sent from my PC, to the node connected to the Arduino through I2C.
Could you please get me started?
Thanks in advance!
There is example code in each components datasheet, towards bottom
of datasheet. Start there. I would first tackle board to board com, then
the PC side. Something simple like transfer a byte from one board to
Youtube and vendor websites, like Phillips (I2C inventor, now NXP) I
would imagine have tutorials, videos.
Thank you very much for the reply Dana! I`ll try to figure it out somehow, with the tools you mentioned.