6 Replies Latest reply on Jul 13, 2015 3:59 AM by eunat

    How do I make 10k+  measurements in a second ?

    eunat

      I am trying to read a voltage(AC) value from a shunt resistor and I am supposed to do measurement very precise with high number of  decimals. I am using a 4m(ohm) shunt resistor and the voltage will be very low like microvolts level. First , I need to amplify it with PGA or OP-AMP then the signal move to the ADC. This is where I confuse ! How do I make 10.000+ measurements with ADC or any kind of component than PSoC5 contains. Thank you for your attention...