Anonymous
Not applicable
Jul 15, 2015
07:56 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 15, 2015
07:56 PM
Now I have two USB 3.0 PCBA, the PID of CYUSB3014 in Device manager of PC, one is 0x00BC, the other is 0x00F3. I used SDK v1.3.3, and the two board all can be recoginzed by PC. But when I load my firmware into RAM using control center, 0x00F3 board is ok but 0x00B board disappeared in device manager and control center. The two boards used different blcok 3014 chip, I want to know what cuased the difference. Note: the two board use the same schematic but not same layout, and the failed board has several other same baords has the same problem.
1 Reply
Anonymous
Not applicable
Aug 02, 2015
12:03 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 02, 2015
12:03 PM
Please refer :
http://www.cypress.com/forum/usb-30-super-speed/ez-usb-fx3-bootloader-driver
Regards,
-Madhu Sudhan