1 Reply Latest reply on Jul 17, 2015 3:58 AM by swang_1407091

    Can the JTAG Pins be left float if they are not used

    swang_1407091

      I am using CY7C1414KV18, and wondering if the TMS/TCK/TDI/TDO pins could be left float if I don't need them in my design. Thanks in advance.

        • 1. Re: Can the JTAG Pins be left float if they are not used
          swang_1407091

          Upon reviewing the Datasheet myself, I think I have found the answer:

             

          Disabling the JTAG Feature 

             

          It is possible to operate the SRAM without using the JTAG feature. To disable the TAP controller, TCK must be tied LOW (VSS) to prevent clocking of the device. TDI and TMS are internally pulled up and may be unconnected. They may alternatively be connected to VDD through a pull-up resistor. TDO must be left unconnected. Upon power-up, the device comes up in a reset state, which does not interfere with the peration of the device.