Anonymous
Not applicable
Aug 02, 2015
08:54 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 02, 2015
08:54 PM
Hi,
I used different sheets for different functions and due to limited space of the sheet. Now I would like to connect two input pins with two output pins which are placed on an other sheet. Is this possible?
The knowledgebase shows a function when creating a project to specify the size of the sheet. This wasn't available in PSoC Creator 3.2; is this correct?
Best regards.
Solved! Go to Solution.
1 Solution
Aug 02, 2015
11:48 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 02, 2015
11:48 PM
Take a square symbol, located under wire tool and slap it on the end of wires on both pages. Then give each wire same name (double-click and type, for example, "strobe"). odissey1
2 Replies
Aug 02, 2015
11:48 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 02, 2015
11:48 PM
Take a square symbol, located under wire tool and slap it on the end of wires on both pages. Then give each wire same name (double-click and type, for example, "strobe"). odissey1
Anonymous
Not applicable
Aug 03, 2015
12:27 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 03, 2015
12:27 AM
Just couldn't find it.
Thank you so much!