2 Replies Latest reply on Aug 13, 2015 5:17 AM by jshirtz

    PSOC creator not assigning pins

    jshirtz

      After designing my schematic to be programmed into my PSOC CY8CKIT-049-42xx, I attempted to build the program. a month ago, when I tried to build the program it built and assigned all the analog placements correctly. however, now when I attempted to build the same design with minor modifications (I deleted a pin), the program wont build and the notice I get is "A (re)build is required to use the analog device editor. Unable to load the necessary information from the cyfit file. Partial/wrong data will be displayed until this has been resolved." how can I solve this problem? no errors are reported in the build either.

      Thank you,
      Jeff