7 Replies Latest reply on Nov 16, 2015 9:56 AM by userc_41086

    Formal parameter to initialize D1 with UDB Editor

      I added a formal parameter, of type int8.  I set it's type to "hardware".


      The parameter was added to the verilog:


       parameter HiCmp = 127;


      I tried to paste my symbol into the UDB Editor's "Configure Datapath Registers" dialog and got:


      Unexpected value: "HiCmp". Expected standard decimal or verilog-style integer literal, e.g. 8'b11001010


      I'm new at this, so I might be missing something obvious.


      Is there a way to use the parameter to set the initial value?