Anonymous
Not applicable
Aug 12, 2015
08:01 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 12, 2015
08:01 PM
Part FM3164-GTR does not respond / answer to impulse / frames sent on i2c bus.
After sent START bit and SLAVE address the FM3164’s should answer by getting datalines acknowledge (ryc.18 from the datasheet) but there was no acknowledgement.
There was no reaction to the released address. The speed was changed to both maximum and minimum settings but this wouldn’t work either.
Please help us, thank you.
1 Reply
Anonymous
Not applicable
Aug 25, 2015
05:10 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 25, 2015
05:10 AM
Hi,
Please double check if the master sends out the correct slave address. If so, please create a tech Support case with us for further Debugging.
Regards,
- Madhu Sudhan