- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I need to know how to determine if flash is protected without trying to reprogram, due to system setup issues.
I looked on Google, and searched in the Communities on cypress.com, and looked in documentation. In documentation, it says the code won't verify if protected.
I'm assuming you have to load the flash programmer program. However, that program appears to only want to verify after reprogramming, unless I really missed something.
Is there a tutorial on verification of flash protection?
I'm assuming the part is locked, as SWD could not connect at all. However, I've had the programmer not connect to parts that were *not* locked, until the 4th, 5th, or more tries, once a program was loaded and operational, so I don't fully trust that as a verification step.
Any suggestions?
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I assume that you need to check if a particular row in the flash is protected or not. You can read the flash from PSoC Programmer. Protected rows will give "X" instead of the data.
Thanks,
Hima
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content