3 Replies Latest reply on Aug 26, 2015 4:58 AM by DaKn_263916

    Psoc 4 Clock output and disabling Crystal



      I am using the PSOC BLE Kit


      Can anyone tell me if there is a delay between outputting a clock signal on the PSOC 4?


      As I am reading the output of the 24MHz Crystal through a pin and its a little bit off.


      Also can a anyone tell me if its possible to put the 24 MHz clock off while the PSOC is asleep to save power while keeping the UDB enabled?




      Attached pic of Waveform. clock using divider 




      Max Foster