8 Replies Latest reply on Nov 22, 2017 10:46 AM by user_469728654

    0-10V DAC Application - Best Bet?

    user_385543602

      Hi,

         

      I have a motor controller that takes  a 0-10V input for control.  The DAC I usually use is an I2C 0-5V version.  Can I use the on board current DAC to create this 0-10V output?  Am I better off using a PSOC 5 with a VDAC and an op amp?

         

      Can the setup on page 5 here create a 0-10V signal?

         

      http://www.cypress.com/documentation/application-notes/an60305-using-psoc-3-and-psoc-5lp-idacs-build-better-vdac

         

      Thank you for your input,

         

      Regards,

         

      Tom