- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am PSoC4 beginner, so I am a little confusing about ECO. When I read PSoC4 datasheet and it explain XTAL24I can input 24-MHz crystal or external clock input. But a diagram in the datasheet show crystal is only connected at XTAL24I pin. Therefore, I suspect if I can input external clock signal into XTAL24I pin.
Please tell me whether I can connect external clock signal into XTAL24I pin or not.
Thank you.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you.
I understand external clock is provided from a designated PSoC4 pin. I think the designated pins is one of P0.4, P2.7, P5.1 in CY8C4247LQI-BL483. So I can not use XTRAL24I.
Is it right?
Best regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In the datasheet is a pinout table, and it looks like XTAL24I (pin 16, 24 Mhz) or XTAL32I/P6.1
(pin 3, 32 Khz) is used when external clock is selected in the clock editor. QFN.
Regards, Dana.