2 Replies Latest reply on Oct 1, 2015 4:35 AM by helic_263931

    I can´t add an operational amplifier in my design.



      I m using a PSoC 7124 BTLE and I cac´t add a single opamp.  This error appears:


      Unable to place component "\Opamp_1:cy_psoc4_abuf\". Either the design is bigger than this chip can handle, or the design is over-constrained and there are not enough resources to satisfy the constraints.


      I am using few thing of the PSoc, and in the and in the project datasheet is saying that I can use 2 OpAmps.


      Any idea,


      Thanks in advance,