- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm trying to follow the steps from pages 13-14 of the quick start guide.
I don't have access to hyperterm (which has been extinct since windows vista), I've tried tera term (as suggested in the guide), and also MTTY (windows) and screen (on OSX).
In all cases the trace statements print junk like this:
HX dcXÊBH Xä „
BÑBѨ B £RH c Bˇ "ÑP o;Ä_ZrÙ ZB à¬∆
JV»Hæ⁄HJ¶HJ⁄Hä⁄HJ⁄HJ⁄HJ⁄HJ⁄Hº⁄HJ¢H∫JHJJHJ¢HJZHJJHJJHJZ∏J∫HºJHJJHJJHJHJZ⁄P 5zX roZ ¬Û÷ ˇHJZ»“ :RV ˇHJ∏J™HΩZHJöHΩJHJJRX⁄PZÛP JHrıH∫JHJ™H∫Z⁄P
I've checked bleapp_trace_enable, SW4 switches, etc. - Does anyone have an idea what could be wrong?
Are there any plans to support the SWD interface and proper debugging in a future version of the SDK & IDE?
Regards
Tim Redfern
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Did you change the serial port settings 115200 N 8 1? They usually default to 9600 N 8 1. If you are getting "garbage" on the screen. That's usually what it is.
I use PuTTY on Windows and CoolTerm on the Mac with no issues.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Did you change the serial port settings 115200 N 8 1? They usually default to 9600 N 8 1. If you are getting "garbage" on the screen. That's usually what it is.
I use PuTTY on Windows and CoolTerm on the Mac with no issues.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Ah yes, thanks, I had omitted to set the speed- I was "speed reading" the guide