- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
CY7C64713上电能正确被识别,用CyControl或者CyConsole加载Examples中固件(比如Bulkloop)到到RAM不能被电脑识别,但是加载同样一个固件(Bulkloop)到64KB EEPROM却能被正确识别,请教这是什么原因?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
Please share the firmware(entire project) that you are using
Could you able to see the device in the device manager after programming the device?
Regards,
Vikas.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
这个固件就是cyperss提供的Bulkloop例程;download之后在设备管理器看不见device,但是c2加载却能看见
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
I don;t understand your response.
Are you using Bulkloop example provided with CY3674 DVK? If not please share the firmware.
What do you mean by "i could able to see C2 load"?
Have you installed the Cy3674 DVK ? If not install the Cy3674 DVK from the link http://www.cypress.com/?rID=14317.
Try to manually bind the drivers. Check whether there is an unkown device in the device manager with the VID/PID 04b4/1004.
Please refer the document" CY3674 Development kit user guider " chapter 6.
Regards,
Vikas.