1 Reply Latest reply on Nov 10, 2015 12:36 PM by user_274318315

    Cannot program FX3 superspeed explorer board from control center

    user_274318315

      Using Windows7x64, the FX3 board is recognized when plugged into a USB3 card with a Renesas controller. The FX3 however appears as a 'Cypress FX3 USB StreamerExample Device'. If I rrun USB control center and attempt to download an image to the board I always get a message with 'Please reset you device to download firmware'. But it never enters what I'd expect to see as DFU mode?

         

      A picture attached. Any help welcomed.

         

      TAIA

         

      Jerry.