Anonymous
Not applicable
Nov 19, 2015
03:11 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 19, 2015
03:11 AM
Hi Folks,
I know that its not the most beautiful way to establish a SPI connection but due to Project history I have to implement an SPI bit banging method.
My Problem is now that the GPIO pins (even with fast slew rate) are too slow!
Do you know a way how I can get faster slew rates?
Thank you in advice.
Labels
- Labels:
-
BLE
1 Reply
Nov 19, 2015
06:40 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 19, 2015
06:40 AM
Welcome in the forum, Niklas.
Why bit-banging? Why not use an SPI component?? And I question that the slew rates are bad, What board do you use, which pins?
Can you post your complete project, so that we all can have a look at all of your settings? To do so, use
Creator->File->Create Workspace Bundle (minimal)
and attach the resulting file.
Bob