7 Replies Latest reply on Dec 9, 2015 4:51 AM by user_1377889

    Help holding the o/p

    user_420283366

      Hello all,

         

      I have coded for the simple buttons on the PSoC 4 Pioneer Board, using the onboard slider elements as Buttons. It has compiled & build OK;

         

      Then I programmed the board, successfully. The output was tuned to respective LED's on board (Red, Yellow, Blue);

         

      But the problem I have is:

         

      1.    It isn't holding the output i.e. I want a Toggled output but it just turns ON when touched & turns OFF when finger is removed.

         

      What should get me out of it?

         

      2.   Also can I have Percentile illumination to the LED's @ OFF state (20%) & ON state (100%) like it was in Ez-Click?

         

      Thanks & Regards-

         

      Amit