1 Reply Latest reply on Dec 15, 2015 6:33 AM by Madhu Lakshmipathy

    CYUSB3014 Jtag debug using CY7C65215??

    jianling.zhao

      I test my CYUSB3014 PCB Board, and use JTAG Port to debug, just like CYUSB3KIT-003 EZ-USB® FX3 SuperSpeed Explorer Kit. I have another CY7C65215 Board configure SCB1 as JTAG mode. My CYUSB3014 Board and CY7C65215 Board connected use TDI, TDO, TCK, TMS, TRST_N, GND.

         

      When I use the method recommended in the CYUSB3KIT-003 user guide. The first step, Eclipse run the external tools, and give bellow message. It seem OK.

         

      ----------------------------------

         

      Open On-Chip Debugger 0.8.0 (2014-12-03-15:43)

         

      Licensed under GNU GPL v2

         

      For bug reports, read

         

          http://openocd.sourceforge.net/doc/doxygen/bugs.html

         

      Warn : Adapter driver 'cy7c65215' did not declare which transports it allows; assuming legacy JTAG-only

         

      Info : only one transport option; autoselect 'jtag'

         

      adapter_nsrst_delay: 200

         

      jtag_ntrst_delay: 200

         

      adapter speed: 1000 kHz

         

      trst_and_srst srst_pulls_trst srst_gates_jtag trst_push_pull srst_open_drain connect_deassert_srst

         

      RCLK - adaptive

         

      adapter speed: 1000 kHz

         

      Info : clock speed 1000 kHz

         

      Info : JTAG tap: fx3.cpu tap/device found: 0x07926069 (mfg: 0x034, part: 0x7926, ver: 0x0)

         

      Info : Embedded ICE version 6

         

      Info : fx3.cpu: hardware has 2 breakpoint/watchpoint units

         

      ------------------------------------------------------------

         

      But when I debug the project, it’s not stable. Sometimes, it report failed load; Sometimes, it go into the debug mode,the first three pictures are the debug mode capture. But when do Resume, it will report Target request failed as the fourth capture.

         

      But when I use CYUSB3KIT-003, it works fine.

         

      I check the connection between CYUSB3014 and CY7C65215, and Eclipse configure, and CY7C65215 configure. It seem all good.

         

      Who can tell me why?