2 Replies Latest reply on Dec 27, 2015 3:37 AM by user_1377889

    Output Pin as Reset, not functional

    sen.li_1509296

      Hi,

         

      Something weird happened when I try to run PSoC 4 BLE. A reset pin needs to be as low as ground ordinarily, and goes up and down to send falling edge as RESET signal. I used a digital output pin with Strong Drive mode to do this reset job on PSoC 4 pioneer KIT, and it works very well;

         

      However, when I tried to use the exact same codes on PSoC 4 BLE KIT, the reset pin is not able to be as low as ground ( not 0 ).

         

      Only High Impedance Digital/Analog mode could be successfully written "0"; however, under those two High Impedance modes, the falling edge control does not work.

         

      Could anyone tell me what can I do with the weird PSoC 4 BLE KIT?

         

      Thank you!