5 Replies Latest reply on Feb 20, 2016 3:02 AM by user_1377889

    UART data transfer

    mangesh.dighe

      Hi.

         

      I am new in psoc. I want to transfer data to other board through UART of PSOC 4. Below I uploaded my code. At the start I only written program for the display sensor data over the TERATERM that time it is giving output properly over TERATERM but then in that I used BLE Profile to get commands from the mobile and now I am getting no output at TERATERM. If you don't mind the please help me. 

        • 1. Re: UART data transfer
          user_1377889

          When you look into the schematics of the BLE Pioneer board you will see that the UART-Tx pin is now on P1_4. When you change that, the USB-UART bridge will work again.

             

           

             

          Bob

          • 2. Re: UART data transfer
            mangesh.dighe

            Thank you sir

            • 3. Re: UART data transfer
              mangesh.dighe

              Sir sorry to bother you. now  I connected Pin P0.5( UART TX) to the pin P1.4 but still I am not getting required output.

                 

              and also sir In my one of serial data transfer project i connected pin P0.5 (UART TX) to pin P1.5 the it was giving output but now I added BLE then output is gone  .

              • 4. Re: UART data transfer
                user_1377889

                OK, too many assumptions and misleads due to language barrier (I am not natively English).

                   

                Your line

                   

                            if(UART_TX_STS_FIFO_EMPTY==1u)

                   


                will fail.

                   

                UART_TX_STS_FIFO_EMPTY is a constant != 1 so the if will always fail.

                   

                UART_PutString() is blocking and waits for the buffer to be free, so there would be no need to wait for an empty UART. If you want to wait better use the appropriate API to get the status and AND (&) the result with UART_TX_STS_FIFO_EMPTY.

                   

                 

                   

                Bob

                • 5. Re: UART data transfer
                  mangesh.dighe

                  Hi,

                     

                  Sorry to bother you again. sir I want to to transfer many motion sensors data one by one using UART of PSOC 4 to the UART of other board. So please guide me for this....

                  • 6. Re: UART data transfer
                    user_1377889

                    You have to write a "Protocol" that assumes a controlled data flow. When you transfer printable ASCII characters only you need a conversion on both sides, but you are able to work with "Message Blocks" These blocks (as a suggestion only) consist of

                       

                    Sensor Number ('00" to "99"

                       

                    Sensor Data (fixed number of digits)

                       

                    Message delimiter (\n or \r)

                       

                     

                       

                    Bob