Anonymous
Not applicable
Dec 28, 2015
03:22 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 28, 2015
03:22 PM
I currently have the CY8CKIT-049 4xxx (http://www.cypress.com/documentation/development-kitsboards/psoc-4-cy8ckit-049-4xxx-prototyping-kits) and I'm using the MiniProg3 to program the device with the usb portion broken off. The problem that I'm having is while the debugger is plugged in, my code runs fine. But whenever the Miniprog is unplugged everything stops.
How do i make the PSOC not dependent on the miniprog3?
2 Replies
Dec 28, 2015
04:24 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 28, 2015
04:24 PM
Do you have another voltage source for the board besides the mini prog?
Anonymous
Not applicable
Dec 29, 2015
06:59 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 29, 2015
06:59 AM
I do, i figured it out. It seems my power supply had a low limit for the current supply causing the PSOC to lose power as soon as miniprog was removed.