Attachments are accessible only for community members.
Jan 07, 2016
02:48 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 07, 2016
02:48 AM
I am debugging EZ-BLE module by using MiniProg3 but showing : -> Warning: dbg.M0039: There was an error running port acquire: Can not acquire SWD device!
All pin of MiniProg3 connected to EZ-BLE according to given data sheet : -> http://www.cypress.com/file/140716/download
*while debugging it showing port acquire problem .
plzz check the attached file of debug configuration
Labels
- Labels:
-
BLE
2 Replies
Jan 07, 2016
07:57 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 07, 2016
07:57 AM
Could be the cable from Mini Prog 3 to your device it could be defective. Have you tried the programmer on another board? Have you verified the connection from the socket to the Ble chip?
Anonymous
Not applicable
Nov 23, 2016
12:39 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 23, 2016
12:39 PM
Check the voltage level before acquiring port. Keep it as 3.3V instead of external and try again. It should work. Hope it helps 🙂