2 Replies Latest reply on Jan 12, 2016 4:49 PM by ropac_285281




      I am modifying an existing application and adding a Wavdac8 to the project.  The wavdac8 is simply generating a 600Hz tone to be used as CW side tone (I hope there are couple amateur radio operators on this forum :)).   When CW is generated by another section of the code, I would like to turn the side tone on and off with the CW generation.  I could simply stop start the component but my gut feeling is that is not the correct method to do it.  Is there another component that could be inserted between the Wavdac8 and the PSoC 5 pin that can basically act as an ON/OFF switch.


      The PSoC 5 will be driving a simple external circuit that basically consists of a transistor to drive a speaker.