5 Replies Latest reply on Jan 13, 2016 6:18 AM by JoMe_264151

    PWM signal Switching between line to line_n at run time


      i am using CYBLE-022001-00 / BLE module and generating 1Hz to 40 Hz PWM signal . some time i need inverted signal of waveform signal (example 1Hz signal ). for that i need two different pin for taking inverting and non-inverting signal out .


      Instead of two GPIO pin  i want to use only single GPIO pin for generating both signal and that switching event must be control through my main() program .




      void TCPWM_SetPWMInvert(uint32 mask)


      Example -


      T0 second  - PWM output through PIN 1 is Non_Inverting


      T0+1 second - PWM output through PIN 1 is Inverting 




      *Please check the attached jpg also.