2 Replies Latest reply on Jan 18, 2016 5:15 PM by user_342122993

    Clocks, Timer, Tolerance and Accuracy Question

    hxinyu_1446496

      I have been using a timer to use as a global clock for one of my programs and there seems to be a slight inaccuracy (about 0.08% lag) on the clock so I adjusted the period to match.

         

      Here is a picture of my timer setup: http://i.imgur.com/AnSkywB.png (also attached)

         

      For both clocks I set tolerance to unchecked. Does this make the inaccuracy worse or better? Will there always be inherent inaccuracy of the cypress timer in the kit? Is there a way that this accuracy can be improved?