1 Reply Latest reply on Feb 11, 2016 2:21 AM by madhul_36

    FX3 Slave FFIO Interface - SLCS#



      Looking at using the CYUSB2014 in a design we had originally used the FX2.  With the FX2 we did not use the SLCS# pin because we used the FLAGD function on that pin instead.  So it looks like we need the SLCS# pin for the FX3 application.  Now we are just writing into the FX3 FIFO no reading.  Can we either tie SLCS# to ground and always have it enabled or could we tie it together with the SLWR# since there doesn't seem to be any timing specification requirements on the SLCS#?




      Thank you