- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hey,
1. I want to make a design which includes DMA on PSoC\PRoC BLE. The datasheets says DMA is supported in PSoC BLE and PRoC.
But, in PSoC Creator this devices are not supported (Can't select them in the "device selector").
Are these devices available or future concept? I'm using PSoC version 3.3
2. Can DMA be used to transfer data from SRAM to external port?
3. Can DMA be used to transfer data from SPI peripheral to external port?
Thanks,
Valery
- Labels:
-
BLE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Welcome in the forum, Valery!
The CY8C4228xxx-BL chips have got 8 DMA channels. Use the Device selector on Creator to verify.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hey,
I can't find this P\N in device selector.
There is no even one BLE device that supports DMA in the device selector table. I'v filtered the table by DMA channels and BLE. the table shows nothing. what's going on?
thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am using Creator 3.3 SP1. Can it be you are using a former version such as CP1?
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Exactly!
I will update now 🙂 thanks