Anonymous
Not applicable
Feb 16, 2016
07:31 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 16, 2016
07:31 AM
Hi,
It's possible measure the current consumption using oscilloscope in Pioneer Kit (CY8CKIT-042-BLE). If so, how?
Thank you.
Labels
- Labels:
-
BLE
2 Replies
Anonymous
Not applicable
Feb 16, 2016
12:14 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 16, 2016
12:14 PM
Hi,
If your oscilloscope supports high accuracy current averaging facility, you can use it. If not, i would recommend you to go for a high end multi meter with current averaging feature.
The current consumption can be measured across the BLE_VDD jumper on the pionerr kit.
Regards,
- Madhu Sudhan
Anonymous
Not applicable
Feb 16, 2016
04:13 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 16, 2016
04:13 PM
Hi Madhu Sudhan,
I tried to use these pins by placing a resistor of 1 ohm and placing the probe of the oscilloscope in parallel with this resistor to measure the voltage drop on it, however to connect the probe short plug kit and working. What can it be?