Jan 12, 2016
08:51 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 12, 2016
08:51 AM
I am designing a PCB using the FX3 chip and I need to know which is the characteristic impedance of the GPIF-II lines. I also know they must be series terminated with 22 ohm resistor but should I place them in a specific location along the transmission line?
Solved! Go to Solution.
1 Solution
Anonymous
Not applicable
Jan 13, 2016
03:37 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 13, 2016
03:37 AM
Hi,
There is no specification on location of the 22 Ohm resistors.
For Impedence, please refer:
Regards,
- Madhu Sudhan
2 Replies
Anonymous
Not applicable
Jan 13, 2016
03:37 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 13, 2016
03:37 AM
Hi,
There is no specification on location of the 22 Ohm resistors.
For Impedence, please refer:
Regards,
- Madhu Sudhan
Jan 13, 2016
04:19 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 13, 2016
04:19 AM
Thanks a lot you've been very helpful!