Cory, you do not tell us which board you actually use. You name the chip, but you do not tell us which CY8CKIT-???? it is. Could be of some help, because some of the pins you're using might be occupied by a board specific function.
How are you equipped? Scope? Logic analyzer??
Please supply us with an actual project that you created, we'll have a look at. To do so, use
Creator->File->Create Workspace Bundle (minimal)
and attach the resulting file.
Bob, my apologies. The board I'm using is CY8CKIT-059. Attached is my project as you asked for. I am testing by using a function generator with a DC offset of around 1 Volt and a 0.5Vpp sinewave at variable frequencies (to test filter). I use an o-scope to measure the input and output voltage waveforms. In this program I was using Pin_1 and "toggle" for debugging purposes.
Cory, you used the WaveDAC component which is designed to generate pre-defined output forms, change the component to a VDAC.
I have found my problem and everything is fixed! Thank You so much for your help over the past few days!
You are always welcome, Cory!