Anonymous
Not applicable
Mar 10, 2016
12:35 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 10, 2016
12:35 AM
Hello,
I'm currently working with the SuperSpeed Explorer Kit (CYUSB3KIT-003) to communicate with an FPGA ( type Altera Cyclone IV ). I have programmed it with the bulkloop example to send to and get Data from the FPGA.
The problem is I'm getting inaccurate Data when clicking on the Transfer Data-OUT and I do believe it is because of a GPIO pin that alternates randomly between 0 and 1.
The question is can I change the pin assignment of the SuperSpeed Explorer Kit to solve my problem ?
Thanks
Labels
- Labels:
-
ispn:38621:1:0
-
l1:314:1:0
1 Reply
Anonymous
Not applicable
Mar 10, 2016
02:03 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 10, 2016
02:03 AM
Hello,
NO, once you configure the FX3 in 16 bit Slave FIFO mode the data lines are fixed . The GPIO[0:15] are configured as data lines. You can refer to the FX3 datasheet (Table 7) regarding these details.
Dhritiman