- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I try to run RTC many times. I have 2 same function for run as timer one RTC: Timer 1 and Timer 2.
When I run only 1 of it it`s work fine but if I run it one after one ( chain ) second timer not create interrupt to stop.
I tried to use 2 RTC but same result.
Attached code
Solved! Go to Solution.
- Labels:
-
BLE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am looking at your program and I am wondering why you are turning the clock on and off for each timer? That is unnecessary as you can just set another Alarm and wait for that to occur then trigger your interrupt.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am looking at your program and I am wondering why you are turning the clock on and off for each timer? That is unnecessary as you can just set another Alarm and wait for that to occur then trigger your interrupt.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I`m just used "RTC_P4_WDT_Example" , if you have example you talk about or you can change my code to make it work I`l appreciate it .