- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm new to all that Cypress stuff. Sorry for having maybe stupid questions.
Is it possible to extend a CY8CKIT-059 with a ez-BLE module? There is a place on the PCB but will it function when soldered? Is there something more to do? Are there any working examples for this setup?
Thanks a lot!
Regards,
Manfred
Solved! Go to Solution.
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Manfred I am sending you the manual for the Ez-Ble part.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Manfred: The CY8CKIT-059LP doesn't have any pads for the Ez-Ble module the pads are for the Mini Prog 3 programmer. the CY8CKIT-043 module does have pads for the Ez-Ble module. You could hook up a Ez-Ble externally if you wanted too.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Your question is interesting.
Your goal is to add BLE for the PSoC 5LP of your CY8CKIT-059 board.
In this case can use a bridge BLE-I2C (or other serial link). There are a few example of BLE project for dedicated dev board.
By connecting the two development boards, your PSoC 5LP can communicate in BLE (via the bridge).
rob1