- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I created a custom project with the CY8C5888LTI-LP097 chip and I have my hardware ready to be programmed. However, I can't actually start a debugging session because the button is greyed out. The only thing I can do is attach to a running target. Is there a reason why this is the case? Did I inadvertently put the wrong confguration in my .cydwr file?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Actually I found the problem. It seems that you cannot debug if you have a "Bootloadable" component in your design. I disabled it and now the debug button is no longer greyed out. Silly me 😛
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Welcome in the forum, Alexandre!
Is the debug mode set to GPIO which disables debugging (set in .cydwr view under "System")
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
It's set to SWD (serial wire debug)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You are probably using a CY8CKIT-059. Can you use Cypress Programmer, select the Kitprog interface and see if the version is 2.16
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yup I am indeed using that kit.
Yes it is version 2.16 in the programmer:
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can you please post your complete project, so that we all can have a look at all of your settings. To do so, use
Creator->File->Create Workspace Bundle (minimal)
and attach the resulting file.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Actually I found the problem. It seems that you cannot debug if you have a "Bootloadable" component in your design. I disabled it and now the debug button is no longer greyed out. Silly me 😛