- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi all,
I need to test the CY5670 USB Dongle as a GATT Server with a bluetooth name, connect it and send e receive command from a UART serial port software terminal
If I start Putty or TeraTerm and set the parameters COM7, Baud rate 115200, Parity Even, Data Bit 8, Stop bit 1, I don't receive any response.
Are there commands documentated to send through COM port to set the bluetooth name, bluetooth discoverable, etc?
Are they Hayes like commands?
Could you help me?
Thanks
Solved! Go to Solution.
- Labels:
-
BLE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
CY5670 USB Dongle is shipped with a default firmware which is intended to work with CySmart PC App. Can you confirm if your requirement is HCI (Host Controller Interface) Mode Operation or use the Dongle as BLE-UART Bridge? (http://www.cypress.com/blog/100-projects-100-days/project-020-uart-ble-bridge)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
CY5670 USB Dongle is shipped with a default firmware which is intended to work with CySmart PC App. Can you confirm if your requirement is HCI (Host Controller Interface) Mode Operation or use the Dongle as BLE-UART Bridge? (http://www.cypress.com/blog/100-projects-100-days/project-020-uart-ble-bridge)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you BMAH.
Now I'm looking for documentation about if is it possible to send commands from the serial interface to the USB dongle; can I disconnect a remote smartphone connected, change the advertising name, assign a specific mac-address, etc?