2 Replies Latest reply on Mar 25, 2016 7:32 PM by adityapanchangam_1560036

    PSOC 5 Capsense board fabrication

    adityapanchangam_1560036

      Hi im designing an application to use capsense buttons with psoc5 cy8ckit-059. i have fabricated a simple capsense board with five 12mm dia copper footprints each connected with a 1 mega ohm resistor. i think this should be ideal for the low end design im trying as i read somewhere. planning to use port 1 pins 2,4,5,6,7 for my 5 capsense buttons. im also using the onboard cmod capacitor. please suggest me if what im doing is correct and also the way in which i have to configure my capsense module in psoc creator. thank you.