- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm in "learn mode" and currently seeing where I get when testing out PSoC101 training video examples using a BLE PROC module. I'm expecting some incompatibilities. Is this one of them.
I'm on lesson 4 (Hardware pins) and found that this would not work for me as get the following error when compiling: "Pin guidance unavailable: 'Pin_SW1(0)' cannot be placed at P4[1]. P4 cannot be used for routed connections. "
Just wondering whether this is an error on my part with my TopDesign schematic or whether this is a limitation with BLE PROC itself.
- Labels:
-
BLE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Just wondering whether this is an error on my part with my TopDesign schematic or whether this is a limitation with BLE PROC itself.I
Neither. The PSoC4 and PRoC have restrictions with routing signals to ports >= 4. When you remove the hardware connection from the pin component you will be able to assign it to a port 4 pin.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Wow would never have worked this one out. Pretty awesome. Have reconfigured my switch to P0.4 and it works! Thanks again.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You are always welcome!
Bob