1 Reply Latest reply on Apr 28, 2016 5:52 PM by jguy_1586666

    PROC module keeps dropping connection

    jguy_1586666

      Hi,

         

      I'm having trouble maintaining a connection with the PROC module (CYBLE-022001) mounted on the board I'm bringing up.  I'm running BLE UART example code (Server code on the PROC and Client on a CY-SMART board).

         

      The two devices continuously connect then disconnect - typically after just a few seconds. 

         

      The same code (slightly different target) runs just fine on the cypress pioneer kit.

         

      I checked power-supply noise on the 3.3V rail (it's less than 40mV pk-pk). I'm using standard BLM21P331 ferrites. XRES is noise-free and high. I don't see any requirement to pull-up or pull-down other signals.

         

      Any suggestions?

         

      -- Jon